Cube Warfare Crossbow!

It suggests that you use wooden skewers as ammo on this badass office crossbow, but I’m totally bending some large paperclips right now to make into darts. Too bad my assistant is on holiday’s for the next month… I’d totally have her make 6 dozen of those things! Hit the jump for the full instructions on how to make your own badass crossbow for the office…Its just an excerpt from John Austin’s must-read new book Mini Weapons of Mass Destruction.

Supplies:

• Pen – 1
• Pencil – 4
• Rubber Band – 7
• Tape – 1
• Wooden Skew (ammo) 1+

The #2 Crossbow is a larger variant of the other bows found in this book. With a structurally solid design and double elastic power, it is equipped to fire large realistic skew arrows. It sports a pen-housing barrel that helps with both accuracy and control.

Step 1:
Using four thin rubber bands, rubber bands, assemble two pairs of unsharpened wooden pencils. Both sets should be identical and tightly secured.

Step 2:
Crisscross the two sets of pencils. Center one of the pencils frames on top of the other towards a selected end. This end will ultimately be the front of your #2 Crossbow. While holding the pairs in place, use one or two rubber bands to fasten the frames into place.

Step 3:
Disassemble the plastic ballpoint pen. You may need a pocketknife or pliers when removing the rear pen cap. The hollowed-out pen housing will be used for your crossbow barrel. Discard all the other pen contents.

Step 4:
Position the pen housing on top of the pencils, as shown, then secure with tape. It is important that the pen housing sits on top of the rubber bands and that the barrel is not obstructed by them.

Step 5:
Slide two wide rubber bands between the tightly secured pencils ends. The pencils should lock the bands into place, but if they don’t add an additional thin rubber bands on the ends. The wider will ultimately provide you with your elastic firepower.

Step 6:
Bring both ends of the rubber bands together and attach them using strong tape. As you secure the bands, try to create a small ammunition pouch with the tape. It is possible you may need several pieces of tape to fasten the bands together securely. Pull the assembly back a few times with your fingers to test.

Step 7:
Your #2 Crossbow is now complete! Slide one wooden skewer (used for cooking) or a 3/16 dowel into the pen housing. Gripping the wood arrow and the rubber bands, pull back and aim your crossbow launcher. Release and watch it fly!

[via How to Build a Pencil Crossbow @ Gizmodo]